The plate can be centered on the junction box or shifted to the left or right. Using the two (2) mounting screws provided, attach the thermostat mounting plate to the junction box.Take the power wires out of the junction box and run them through the large opening in the center of the mounting plate.Separate the mounting plate from the thermostat.Loosen the screw at the top of the thermostat without removing it.Install your thermostat about 5 ft (1.5 m) from the floor on an inside wall facing the heating system.To install this thermostat, you will need a #2 Phillips screwdriver.The box contains one (1) thermostat with mounting plate, two (2) mounting screws, two (2) twist-on wire connectors, and one (1) owner’s manual.Overload protection device external to the control: circuit breaker (refer to local electrical code) BEFORE YOU GET STARTED The thermistor used as a sensor carries no-load current Independently mounted control for surface mounting Y Pollution degree 2 Software Class A Rated impulse voltage Category II overvoltage (1500 V) ![]() Humidity 5 % to 98 % without condensation Action Type 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |